Knowledge Base

Knowledge base about dynamic balancing machines, FAQs of JZABM balancing machine equipment, and other introductions and explanations related to balancing machines.

Dynamic Balancing Accuracy Grade

The part that rotates around the axis in the machine is called the rotor of the machine. If a rotor has a uniform mass distribution and is manufactured and installed properly, the operation is balanced. Ideally, the pressure on the bearing, other than gravity, is the same as when the rotor is no ...

Read more
How a rotor balance is done?

Balancing is the process of attempting to improve the mass distribution of a rotor, so that it rotates in its bearings without uncompensated centrifugal forces. This is usually done by adding compensating masses to the rotor at prescribed locations, or removing excessive masses from specified lo ...

Read more
What is an unbalance

A rotor has axes around which it “naturally prefers” to rotate usually called the principal axes. Intuitively, they are axes which pass through the center of mass and the mass distribution around these axes are uniform and symmetrical. A physical rotor has a physical axis of rotation,i.e. engine ...

Read more
Why a dynamic balancing machine is necessary for rotatory parts?

Dynamic balancing is a process of rotor testing and calibrating, so as to meet the requirements of use. When parts are rotating, such as various motor rotors, transmission shafts, spindles, fans, water pump impellers, fans, motors and steam turbines. Rotors, etc., are collectively referred to as ...

Read more
Balancing Machine Regular Maintenance Items

Automatic Balancing Machine Regular Maintenance Items Clean the machine from dust and iron and keep the machine table clean. Check if the consumables on the machine have been damaged (For example, testing station belt) Spray anti-rust oil to prevent the machine from rustin ...

Read more
How to use Jizhi Balancing Machine?

Common Questions in Balancing Machine The data is large and the angle is large. Check as follows: Check that the speed is normal and check the belt for wear. Detection was unsuccessful There are generally two reasons for the unsuccessful detection. The first is tha ...

Read more

Dynamic Balancing Accuracy Grade

How a rotor balance is done?

What is an unbalance

Why a dynamic balancing machine is necessary for rotatory parts?

Balancing Machine Regular Maintenance Items

How to use Jizhi Balancing Machine?